Scanlab RTC6 PCIe Board Installation And Operation Manual page 27

Flash Memory
FPGA
Hardware Reset
Hard Jump
High-Bandwidth Return Channel
Multiplexing
iDRIVE Scan Systems
Image Field
intelliSCAN
Jump Command
Laser Control Signals
LSB
Mark Command
McBSP
RTC6 boards
Doc. Rev. 1.0.21 en-US
1 About this Manual
Non-volatile memory on the RTC6 board that replaces the EEPROM
of the RTC5 board.
Field programable gate array on the RTC6 board.
New start after powering the RTC6 board.
Synonym: "power up", "power cycle".
Direct output to a specified position.
Decomposition into Microsteps
Functionality not yet released.
In this manual, the term subsumes, for example, the following
SCANLAB products: intelliSCAN, intelliSCAN
intelliDRILL, intellicube, intelliWELD, varioSCAN
powerSCAN II 50i, excelliSCAN.
Synonym: Working Field.
In this manual, the term subsumes, for example, the following
SCANLAB products: intelliSCAN, intelliSCAN
intelliDRILL, intellicube, intelliWELD, powerSCAN II 50i.
Serves to move the scan system axes to a new position while the
laser is off.
See also Section "Jump Commands", page
See 2D Jump Commands, page 310
page 310.
LASER1, LASER2, LASERON. See, for example,
"Enabling, Activating and Switching Laser Control Signals",
page 184.
Least Significant Bit.
Serves to perform marking motions while the laser is switched on.
Examples: mark, arc and ellipse.
See 2D Mark Commands, page
page 310.
Multi channel Buffered Serial Port.
into a single 10 µs clock cycle.
, intelliSCAN
de
,
de
, intelliSCAN
de
137.
and 3D Jump Commands,
Chapter 7.4.1
310, and 3D Mark Commands
,
se
,
se
(1)
,
27