Set_Wobbel_Vector_2; Set_Zoom; Set_Zoom_List - Scanlab RTC6 PCIe Board Installation And Operation Manual

Undelayed

set_wobbel_vector_2

Short List
Command
Like set_wobbel_vector. However, only for set_wobbel_control(
Function
Call set_wobbel_vector_2( dTrans, dLong, Period, dPower, dPower2, Ctrl )
Parameters dTrans
dLong
Period
dPower
dPower2
Ctrl
Out-of-range values are clipped to the boundary values.
Comments • set_wobbel_vector_2 can only be used with set_wobbel_control(
• Like set_wobbel_vector.
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 631, OUT 632.
References set_wobbel_vector
Ctrl Command set_zoom
Call set_zoom( Zoom )
Comments • This command is described, for example, in the manual for the intelliWELD II FT.

set_zoom_list

Undelayed
Short List
Command
set_zoom_list( Zoom )
Call
Comments • This command is described, for example, in the manual for the intelliWELD II FT.
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Like set_wobbel_vector.
Like set_wobbel_vector.
Like set_wobbel_vector.
Microstep of the relative laser power. Refers to
As a 64-bit IEEE floating point value.
Allowed value range: [–1.0...+1.0].
Microstep of the relative laser power. Refers to
As a 64-bit IEEE floating point value.
Allowed value range: [–1.0...+1.0].
Reserved.
As an unsigned 32-bit value.
Ctrl
= 8 ).
ANALOG OUT1.
ANALOG OUT2.
Ctrl
= 8 ).
780