Scanlab RTC6 PCIe Board Installation And Operation Manual page 839

Normal List wait_for_1_axis
Command
Comments • The following command calls are executed in the same way:
(cont'd)
– wait_for_1_axis( Value, EncoderNo + 19, Mode, 0 ) =
wait_for_encoder_mode( Value, EncoderNo, Mode )
and
– wait_for_1_axis( Value, EncoderNo + 19, Mode+16, 0 ) =
wait_for_encoder_mode( Value, EncoderNo, Mode )
and
– wait_for_1_axis( Value, 6, Mode, 0 ) =
wait_for_mcbsp( Axis, Value, Mode )
and
– wait_for_1_axis( Value, Axis×4+10, Mode+16, 0 ) =
wait_for_mcbsp( Axis, Value, Mode )
and
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 617, OUT 617, RBF 623.
References wait_for_2_axes
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
set_fly_2d session
set_fly_x/set_fly_y session
set_fly_x_pos session
set_fly_x_pos/set_fly_y_pos session
839