Park_Return_1_Axis - Scanlab RTC6 PCIe Board Installation And Operation Manual

Variable

park_return_1_axis

List Command
Function "Fly Extension"
intermediate parking position to the specified absolute position in the 2D
Restriction If the Option Processing-on-the-fly
carries-out the jump to the specified new output position.
Call park_return_1_axis( Mode, Axis, RetPos )
Parameters Mode
Axis
RetPos
Comments • Being an
"Classic" Processing-on-the-fly commands (see Footnote,
• See
""Fly Extension" Commands", page
• See also comments on park_return.
• park_return_1_axis can be used to jump back to park_position_1_axis.
• If a Processing-on-the-fly correction has been previously deactivated at the specified
axis by park_position_1_axis(
park_return_1_axis switches it back on again.
• With an unallowed parameter value, park_return_1_axis is replaced by a
(get_last_error
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 617, OUT 617, RBF 623.
References park_return_2_axes
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Command: Moves the output position for 1
= 0: Return position is ignored.
> 0: Return position. Absolute coordinate in the virtual
As an unsigned 32-bit value.
Axis from Table 3, page
As an unsigned 32-bit value.
Allowed values: 1...2.
Absolute axis coordinate of the new output position. In bits.
As a signed 32-bit value.
Out-of-range values are clipped to the boundary values.
"Fly Extension" Command, park_return_1_axis must not be used mixed with
Chapter 8.6 "Processing-on-the-fly", page 242
return code RTC6_PARAM_ERROR).
Axis
is not enabled, then park_return_1_axis only
259.
and Section
259.
Mode = 0 ) or park_position_2_axes(
with jump speed from the
Image Field.
Image Field.
page 242).
Mode
= 0 ) then
list_nop
569