Get_Error - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command get_error
Result Bit #13
(cont'd)
Bit #14
Bit #15
Bit #16
Bit #17
Bit #18
...
Bit #30
Bit #31
Comments • For error handling see
• get_error and n_get_error are available even without explicit access rights to a
specific RTC6 board.
• The board-specific error variables
Handling", page
• Bit #0 = 1 (error constant: RTC6_NO_PCIE_CARD_FOUND = 1 ) means that no
RTC6 PCIe Board has been found
Boards).
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
= 1: General Ethernet error. May
occur, for example, when trying
to switch by select_rtc
acquire_rtc from
RTC6 PCIe Board to
RTC6 Ethernet Board. Further
information is provided by
n_get_error on the addressed
RTC6 Ethernet Board.
Reserved.
= 1: Unsupported Windows
version. May only occur during
init_rtc6_dll.
Reserved.
= 1: Unsupported BIOS version.
Reserved.
...
Reserved.
= 1: Can occur exclusively in
Remote Interface Mode:
Invalid Command Telegram.
See Section "Error Codes for
get_error/get_last_error
Occurring in
Remote Interface Mode Only",
page 919.
Chapter 6.8 "Error Handling", page
LastError
130) are neither generated nor altered by get_error.
(init_rtc6_dll
RTC6_ETH_ERROR
or
–
RTC6_UNSUPPORTED_WINDOWS
–
RTC6_UNSUPPORTED_BIOS
–
RTC6_REMOTE_ERROR
130.
AccError
and (see Chapter 6.8 "Error
does not search for RTC6 Ethernet
= 8192
= 32768
= 131072
= 2 147483648
400