Set_Delay_Mode_List - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command set_delay_mode
JumpLengthLimit 0...(2
RTC4RTC6 Unchanged functionality. In addition: extended value range.
In RTC4 Compatibility
by 16. The allowed value range decreases accordingly.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_scanner_delays, load_varpolydelay,
Multiple List

set_delay_mode_list

Command
Like set_delay_mode, but a list command.
Function
set_delay_mode_list( VarPoly, DirectMove3D, EdgeLevel, MinJumpDelay,
Call
JumpLengthLimit )
VarPoly
Parameters
DirectMove3D
EdgeLevel
MinJumpDelay
JumpLengthLimit Like set_delay_mode.
Comments • See set_delay_mode.
• set_delay_mode_list requires two list storage positions.
• set_delay_mode_list is executed as two undelayed short list commands.
• Any still-pending delayed short list command is executed first.
RTC4RTC6 New command.
RTC4 Compatibility
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_delay_mode
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
32
–1) Jump length
JumpLengthLimit > 0 enables
Jump Delays"
If the jump vector is longer than this value, then the
fixed Jump Delay
inserted. For all shorter jump lengths, a linearly
interpolated "Variable
between MinJumpDelay and the
calculated and inserted, see
JumpLengthLimit = 0 disables
Jump Delays"
As an unsigned 32-bit value.
Mode, the RTC6 multiplies the specified value for JumpLengthLimit
set_delay_mode_list
Like set_delay_mode.
Like set_delay_mode.
Like set_delay_mode.
Like set_delay_mode.
Mode: see set_delay_mode.
limit. In bits.
"Variable
mode.
(see set_scanner_delays) is
Jump Delay" (page
Jump Delay
Figure 36.
"Variable
mode.
148)
is
629