Set_Start_List; Set_Start_List_1; Set_Start_List_2 - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command set_start_list
Function Opens the
the start of the specified list ("List 1" or "List 2").
set_start_list( ListNo )
Call
ListNo
Parameters
Comments • set_start_list is synonymous with
• Alternatively,
RTC4RTC6 Unchanged functionality.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
execute_list, read_status,
References
Ctrl Command set_start_list_1
Function See set_start_list.

set_start_list_1()

Call
RTC4RTC6 Unchanged functionality.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_start_list
Ctrl Command set_start_list_2
Function See set_start_list.

set_start_list_2()

Call
RTC4RTC6 Unchanged functionality.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_start_list
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
RTC6 List Memory for writing of list commands and sets the input pointer to
Number of the list in which the input pointer should be set.
As an unsigned 32-bit value.
Allowed values: [uneven: "List 1", even: "List 2"].

set_start_list_1

and
set_start_list_pos
set_start_list_pos for Pos = 0.
set_start_list_2
(with no parameter) can be used.
746