Scanlab RTC6 PCIe Board Installation And Operation Manual page 1001

Changes to Document Revision
Where
Global
Chapter 1 "About this Manual", page 24
Section "Folder RTC6 Tools", page 34
Chapter 4.4 "Master Socket Connector,
Slave Socket Connector", page 66
eth_set_high_performance_mode,
page 379
get_error, page 398
get_list_pointer, page 413
set_laser_control, page 668
set_mcbsp_out_oie_ctrl, page 696
set_mcbsp_out_oie_list, page 696
set_vector_control, page 762
wait_for_encoder_mode, page 845
write_port_list, page 862
Chapter 16.7.1 "Upgrading BIOS-ETH",
page 909
Chapter 16.8 ""High Performance Mode"",
page 916
RTC6 boards
Doc. Rev. 1.0.21 en-US
21 Appendix F: Change Index
1.0.20 en-US from Document Revision
What
Document Revision
• 1.0.20 en-US
applies to RTC6 Software Package
(a)
• V1.14.1
Editorial change.
Software change.
Hardware change. #149963 (previously: #117241).
Software change.
Software change.
see page 400.
Editorial enhancement. New comment,
Editorial enhancement. Further clarification with
Bit #4.
Software change.
Software change.
Software change.
Editorial change.
"Normal List Command" (not: "Multiple List Command").
Software change.
Software change.
Software change.
Boards: "High Performance
1.0.19 en-US
(a)
BIOS-ETH 35.
(a)
New command.
(a)
Error bit Bit #17 no longer "reserved",
page
(a)
New command.
(a)
New command.
Ctrl
= 8.
wait_for_encoder_mode
(a)
New command.
(a)
BIOS-ETH 35.
(a)
New functionality for RTC6 Ethernet
Mode".
413.
Bit #3 and
is category
1001