Laser_Signal_On; Laser_Signal_On_List - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command laser_signal_on
Function Turns on the

laser_signal_on()

Call
Comments • Caution! Check the beam path before turning on the laser!
• The
defined by further commands, and enabled by
before they can be switched on with laser_signal_on, see
page
• laser_signal_on is intended for turning on the laser directly, for example, for
alignment purposes.
• The
• laser_signal_on is not executed
– the
– the
• laser_signal_on is even executed, if:
– a list has been paused by
RTC4RTC6 Unchanged functionality.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References laser_signal_off
Normal List

laser_signal_on_list

Command
Function Like laser_signal_on, but a list command and never ignored.
laser_signal_on_list()
Call
RTC4RTC6 Unchanged functionality.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References laser_signal_on
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Signals for "Laser Active" Operation
Signals for "Laser Active" Operation
184.
Signals for "Laser Active" Operation
BUSY list execution status
INTERNAL-BUSY list execution status
set_wait (PAUSED list execution status
immediately.
must first be selected by set_laser_mode,
set_laser_control
Chapter 7.4 "Laser Control",
must be turned off by laser_signal_off.
(get_last_error return code RTC6_BUSY), if:
is set
is set
or enable_laser
set)
474