Read_Analog_In - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command read_analog_in
Function Reads in the analog input values:
• ANALOG IN0
RTC6 PCIe Board
• ANALOG
RTC6 Ethernet Board
Returns them as 12-bit digital values.
AnalogValue = read_analog_in()
Call
Result As an unsigned 32-bit value.
Bit #0
...
Bit #11
Bit #12
Bit #13
Bit #14
Bit #15
Bit #16
...
Bit #27
Bit #28
Bit #29
Bit #30
Bit #31
Comments • See also
• read_analog_in sets the old bits
As soon new data are available at the corresponding analog input they are
automatically set to 0.
• The analog input values
set_trigger/set_trigger4/set_trigger8
Bit #31) are not recorded. The format of the data is
((ANALOG IN1
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_trigger, set_trigger4,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
and ANALOG IN1 at the "McBSP/ANALOG" socket connector of the
IN0, and ANALOG IN1 at the
ANALOG IN0 input value as 12-bit digital value.
= 0. Channel number.
= 0.
= 0.
Old bit for ANALOG IN0.
ANALOG IN1 input value as 12-bit digital value.
= 1. Channel number.
= 0.
= 0.
Old bit for ANALOG IN1.
Section "Analog Input Ports", page
(Bit #15
(ANALOG IN0
<< 16) + ANALOG
set_trigger8
SPI/ANA/UART Socket Connector
86.
and Bit #31) to 1 after reading.
and ANALOG IN1) can be recorded by
(signal 54). However, the old bits
IN0).
of the
(Bit #15 and
579