Set_Rot_Center; Set_Rot_Center_List - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command set_rot_center
Function Sets the rotation center of a Processing-on-the-fly rotation correction (see
set_fly_rot_pos).
set_rot_center( X, Y )
Call
X
Parameters
Y
Comments • For Processing-on-the-fly correction, see
Movements", page
• The position of the rotation center should be defined by set_rot_center or

set_rot_center_list

set_fly_rot
• The rotation center can also lie outside the
to 32x the
• Usage of a second scan head is only practical if it is set up for exactly the same
rotational center.
RTC4RTC6 Unchanged functionality. In addition: increased value range.
In RTC4 Compatibility
The allowed value range decreases accordingly.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_fly_rot,
Delayed Short set_rot_center_list
List Command
Like set_rot_center, but a list command.
Function
set_rot_center_list( X, Y )
Call
X
Parameters
Y
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References

set_rot_center

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Position of the rotation center referenced to the zero point (0|0) of the
Field.
As a signed 32-bit value.
24
Allowed value range: [–2
Like X (analogously).
247.
before the Processing-on-the-fly correction is activated by
or set_fly_rot_pos.
Image Field.
Mode, the RTC6 multiplies the specified values for X and Y by 16.
set_fly_rot_pos
Like set_rot_center.
Like set_rot_center.
24
...(2 –1)].
Chapter 8.6.3 "Compensating Rotary
Image Field. The allowed area is equivalent
set_fly_rot and
Image
720