Scanlab RTC6 PCIe Board Installation And Operation Manual page 837

Ctrl Command verify_checksum
Function Checks or creates the checksum of a correction file.
verify_checksum( Name )
Call
Name
Parameters
Result Result of the test. As an unsigned 32-bit value.
= 0:
= 1:
= 2:
= 3:
Comments • Verification of correction file downloads only works for files that contain a checksum
(see
• The verify_checksum command is available even without explicit access rights to a
particular RTC6 board.
• verify_checksum is not available as a multi-board command.
• The programs
1.01) together with RTC5Base.dll (version 1.0.0.4) already automatically create check
sums for the output files.
• The board-specific error variables
Handling", page
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_verify
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Name of the correction file.
As a pointer to a \0-terminated ANSI string.
No error (the tested checksum is OK.).
A checksum has been newly created (no info about file integrity).
The tested checksum is incorrect.
A checksum could not be determined (file error, etc.).
Loading of correction files, page 132
CorrectionFileConverter.exe
130) are neither generated nor altered by verify_checksum.
and set_verify).
(version 1.04) and correXion5.exe (version
LastError and AccError (see Chapter 6.8 "Error
837