Set_Offset; Set_Offset_List - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command set_offset
Function Defines:
• The offset for coordinate transformations, see
Transformations", page
• The global offset in virtual
Virtual Image Field", page 169
Call set_offset( HeadNo, XOffset, YOffset, at_once )
Parameters HeadNo
XOffset
YOffset
at_once
• set_offset has the same effect as set_offset_xyz, but leaves
Comments
RTC4RTC6 Unchanged first functionality (offset definition).
See set_offset_xyz.
RTC5RTC6 Unchanged functionality.
See set_offset_xyz.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_offset_list, set_offset_xyz, set_angle, set_matrix,
Variable

set_offset_list

List Command
Like set_offset_xyz, but a list command.
Function
set_offset_list( HeadNo, XOffset, YOffset, at_once )
Call
HeadNo
Parameters
XOffset
YOffset
at_once
RTC4RTC6 See set_offset_xyz.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_offset_xyz
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
224.
Image Field, see
See set_offset_xyz.
See set_offset_xyz.
See set_offset_xyz.
See set_offset_xyz.
Like set_offset_xyz. However, HeadNo = 4 is not available.
Like set_offset_xyz.
Like set_offset_xyz.
Like set_offset_xyz_list.
Chapter 8.2 "Coordinate
Section "Coordinate Transformations in the
ZOffset
set_scale
unchanged.
706