Eth_Boot_Dcmd; Eth_Boot_Timeout - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command eth_boot_dcmd
Function Standalone
boot command for
RTC6 Software Package 
Prerequisite

eth_boot_dcmd()

Call
Parameters None.
Result None.
Comments • The definition refers to the subsequent control command, that is, list commands in
between do not matter.
• The boot definition is omitted without replacement, if the defined control command
is not permitted for booting, see
Automatic Booting", page
• eth_boot_dcmd is only allowed with RTC6 Ethernet Boards.
Otherwise, a
• See
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 618, OUT 618, RBF 623.
References

eth_boot_timeout

Ctrl Command eth_boot_timeout
Function Standalone
Boot Phase 1
RTC6 Software Package 
Prerequisite
eth_boot_timeout( TimeOut )
Call
TimeOut
Parameters
Result None.
Comments • eth_boot_timeout is only allowed with RTC6 Ethernet Boards.
Otherwise, a
• TimeOut = 0 deactivates the waiting time. The boot process waits endlessly for an
/START.
• Boot Phase 2
• See
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 618, OUT 618, RBF 623.
eth_boot_dcmd
References
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Functionality: Defines the next following control command as a
Standalone Operation
V1.7.0 and
912.
get_last_error return code
Chapter 16.7 "Standalone Functionality", page
Functionality: Sets the waiting time for the automatic transition from
to Boot Phase 2.
V1.7.0 and
Waiting time. In s.
As an unsigned 32-bit value.
get_last_error
return code
starts immediately when an /START is triggered within the waiting time.
Chapter 16.7 "Standalone Functionality", page
Mode.
 26.
BIOS-ETH
Chapter 16.7.5 "Control Commands Allowed for
RTC6_TYPE_REJECTED
908.
 26.
BIOS-ETH
RTC6_TYPE_REJECTED
908.
is generated.
is generated.
355