Set_Scanahead_Speed_Control - Scanlab RTC6 PCIe Board Installation And Operation Manual

Real time control of scan systems and lasers rtc6 software package v1.16.0
Table of Contents

Advertisement

Ctrl Command set_scanahead_speed_control
Function
Only for scan systems with SCANahead technology, for example, the excelliSCAN.
Controls the Scanner Delays either depending on the target speed or actual achievable
speed.
set_scanahead_speed_control( Mode )
Call
Mode
Parameters
Comments
• Mode with:
– Bit #0
– Bit #1
– Bit #n = 0
– Bit #n = 1
• Default after load_program_file: Mode = 2.
RTC4RTC6
New command.
RTC5RTC6
New command.
Version info
Available as of version DLL 610, OUT 610.
Last change with version OUT 611: adjustment of Laser Delays.
References
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Modus.
As an unsigned 32-bit value.
controls mark commands
controls jump commands
controls the Scanner Delays depending on the target speed
controls the Scanner Delays depending on the actual
achievable speed
731

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RTC6 PCIe Board and is the answer not in the manual?

Related Products for Scanlab RTC6 PCIe Board

This manual is also suitable for:

Rtc6 ethernet board

Table of Contents

Save PDF