Get_List_Serial; Get_List_Space - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command get_list_serial
Function Returns the number of the serial-number-set most recently selected by
select_serial_set_list
serial number of this serial-number-set.
LastMarkedSerialNo = get_list_serial( &Set )
Call
Result Serial number.
As a 64-bit IEEE floating point value.
Returned Set
parameter
values
Comments • The serial number queried by get_list_serial is typically the one most recently marked
by mark_serial
• For usage of get_list_serial, see
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References select_serial_set_list,
Ctrl Command get_list_space
Function Returns the amount of free
can still be loaded from the input pointer's current position to the last position in the
respective list.
Call ListSpace = get_list_space()
Result Number of free list positions.
As an unsigned 32-bit value.
Comments • If an indexed subroutine or indexed character set is currently being loaded into the
protected
still-available protected memory (otherwise the input pointer is not located in the
protected area).
RTC4RTC6 get_list_space has been made available on the RTC4 to support the
Mode and returns the distance between the input pointer and output pointer. The RTC6
does not support the
queried by
queried by
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References get_input_pointer, get_status, get_out_pointer,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
(or of serial-number-set 0 after load_program_file) and the current
Number of the selected serial-number-set.
As a pointer to an unsigned 32-bit value.
or mark_serial_abs.
Chapter 7.5.2 "Marking Serial Numbers", page
get_serial
RTC6 List
RTC6 List Memory area "List 3", then get_list_space returns the amount of
RTC4-Circular Queue
get_input_pointer or get_list_pointer
get_status or get_out_pointer.
Memory, hence the number of list commands that
Mode. The input pointer position can be
and the output pointer position can be
get_list_pointer
210.
RTC4-Circular Queue
414