Set_Input_Pointer - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command set_input_pointer
Function Opens the
the specified absolute address in
set_input_pointer( Pos )
Call
Pos
Parameters
Comments • The next list command is stored at the specified address and all further list commands
at the subsequent addresses in the selected list.
• set_input_pointer performs basically like
But set_input_pointer sets the input pointer based on a specified absolute memory
address, whereas
memory address.
• For Pos 
RTC4RTC6 Unchanged functionality.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_start_list_pos,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
RTC6 List Memory for writing with list commands and sets the input pointer to
RTC6 List Memory
Position (absolute memory address) of the input pointer.
23
[0...(2 –1)].
As an unsigned 32-bit value.
set_start_list_pos
Mem1 Mem2 (see config_list), Pos is set to 0.
+
get_input_pointer
("List 1" or "List 2").
set_start_list_pos (see comments there).
uses a specified list number and a relative
660