Scanlab RTC6 PCIe Board Installation And Operation Manual page 859

Ctrl Command write_hi_pos
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
get_hi_pos, get_auto_cal,
References
Ctrl Command write_image_eth
Function Standalone
a binary file on the PC and saves it to the
Prerequisite RTC6 Software Package 
Result = write_image_eth( Name )
Call
Name
Parameters
Result
Result
Comments • write_image_eth is not executed
– the
– the
• If the Name cannot be opened, a
generated.
• During the execution of read_image_eth the 10 µs clock cycle of the
interrupted for up to 2 minutes.
• write_image_eth is only allowed with RTC6 Ethernet Boards.
Otherwise, a
• See
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 618, OUT 618, RBF 623.
References read_image_eth,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
auto_cal
Functionality: Reads out data for automatic booting from
V1.7.0 and
Name of the binary file.
As a pointer to a \0-terminated ANSI string.
Result
Error code. Like
As an unsigned 32-bit value.
BUSY list execution status
INTERNAL-BUSY list execution status
get_last_error return code
Chapter 16.7 "Standalone Functionality", page
store_program
NAND Memory.
BIOS-ETH  26.
of read_image_eth.
return code RTC6_BUSY), if:
(get_last_error
is set
is set
get_last_error return code
RTC6_TYPE_REJECTED
908.
RTC6_PARAM_ERROR
is
DSP is
is generated.
859