Set_Scanner_Delays; Set_Serial - Scanlab RTC6 PCIe Board Installation And Operation Manual

Delayed Short

set_scanner_delays

List Command
Function Sets the
set_scanner_delays( Jump, Mark, Polygon )
Call
Jump
Parameters
Mark
Polygon
Comments • See also
• Variable Delays for jumps and Polylines can be set by set_delay_mode.
• The specified delays are automatically adjusted by the RTC6 to avoid laser control
errors, see
• The default setting after
set_scanner_delays( 9, 6, 3 ) .
RTC4RTC6 Unchanged functionality. In addition: increased value range.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
set_delay_mode,
References
Ctrl Command set_serial
Function Sets the starting serial number of the serial-number-set most recently selected by
select_serial_set
number-set to 1.
set_serial( No )
Call
No
Parameters
Comments • set_serial is synonymous with
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_serial_step,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Scanner Delays.
Scanner delay of type:
1 bit equals 10 µs.
Allowed value range: [0...(2
Scanner delay of type:
1 bit equals 10 µs.
Allowed value range: [0...(2
Scanner delay of type:
1 bit equals 10 µs.
Allowed value range: [0...(2
Chapter 7.2.2 "Scanner Delays", page
Section "Automatic Delay Adjustments", page
load_program_file
set_laser_delays
(= 0 after load_program_file) and sets the increment size for this serial-
Serial number. As an unsigned 32-bit value.
Allowed value range: [0...(2
select_serial_set
Jump Delay. As an unsigned 32-bit value.
32
–1)].
Mark Delay. As an unsigned 32-bit value.
32
–1)].
Mark Delay. As an unsigned 32-bit value.
32
–1)].
147.
corresponds to
32
–1)].
with Step = 1 (see comments there).
set_serial_step
155.
732