Set_Auto_Laser_Params; Set_Auto_Laser_Params_List - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command set_auto_laser_params
Function Specifies the to-be-controlled signal parameter of the "Automatic Laser Control", the 100%
value and its corresponding limit values.
set_auto_laser_params( Ctrl, Value, MinValue, MaxValue )
Call
Ctrl
Parameters
Value
MinValue
MaxValue
Comments • For information on using set_auto_laser_params, see
Laser Control"", page
• The meaning of the parameters is identical to that of
comments there). However, set_auto_laser_params can neither start nor terminate
"Automatic Laser Control".
• If the value for Ctrl is invalid (0 or > 7), then set_auto_laser_params is not executed
(get_last_error
RTC4RTC6 New command.
RTC4 Compatibility
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
Last change DLL 609, OUT 609, RBF 613: Ctrl = 7.
References set_auto_laser_control,
Delayed Short

set_auto_laser_params_list

List Command
Function Like set_auto_laser_params, but a delayed short list command.
set_auto_laser_params_list( Ctrl, Value, MinValue, MaxValue )
Call
Ctrl
Parameters
Value
MinValue
MaxValue
• If the value for Ctrl is invalid (0 or > 7), then set_auto_laser_params_list is replaced
Comments
with a
RTC4RTC6 New command.
RTC4 Compatibility
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
Last change DLL 609, OUT 609, RBF 613: Ctrl = 7.
References

set_auto_laser_params,

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
The to-be-controlled signal parameter (see set_auto_laser_control).
Allowed value range: [1...7].
100% value. See set_auto_laser_control.
Lower range limit. See set_auto_laser_control.
Upper range limit. See set_auto_laser_control.
197.
return code RTC6_PARAM_ERROR).
Mode: see set_auto_laser_control.
set_auto_laser_params_list
Like set_auto_laser_params.
Like set_auto_laser_params.
Like set_auto_laser_params.
Like set_auto_laser_params.
return code RTC6_PARAM_ERROR).
list_nop (get_last_error
Mode: see set_auto_laser_control.
set_auto_laser_control
Chapter 7.4.9 ""Automatic
set_auto_laser_control
(see also
617