Arc_Abs - Scanlab RTC6 PCIe Board Installation And Operation Manual

Normal List

arc_abs

Command
Function Moves the laser focus from the current position at mark speed along an arc with the
specified angle and center point (absolute coordinate values) within a 2D
arc_abs( X, Y, Angle )
Call
X
Parameters
Y
Angle
Comments • If the mark speed has not been previously explicitly set by
set_mark_speed_ctrl, then the marking is executed at a predefined mark speed of
1,000 bits/ms.
• The
of the marking (or remain on after a directly preceding
"Arc"
account, see
Control", page
Exception: zero-length
RTC4RTC6 Unchanged functionality. In addition: increased value range.
In RTC4 Compatibility
The allowed value ranges decrease accordingly.
RTC5RTC6 Unchanged functionality. In addition: increased value range.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_mark_speed, set_scanner_delays, arc_rel, timed_arc_abs, mark_abs, arc_abs_3d,
mark_ellipse_abs
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Absolute x coordinate of the arc center. In bits.
As a signed 32-bit value.
Allowed value range: [–268,435,456...+268,435,455].
Out-of-range values are clipped to the boundary values.
Like X (analogously).
Arc angle. In degrees.
As a 64-bit IEEE floating point value.
A positive sign means "clockwise".
Allowed value range: [–3,600.0°...+3,600.0°] (±10 full circles).
Out-of-range values are clipped to the boundary values.
Signals for "Laser Active" Operation
Command). The defined
Chapter 7.2 "Delay Settings – Coordinating Scan Head Control and Laser
145. Note that other delays are executed in
"Arc" Commands, see
Mode, the RTC6 multiplies the specified values for X and Y by 16.
are automatically turned on at the beginning
[*]mark[*] Command
Scanner Delays and Laser Delays
Section "Notes", page
Image Field.
set_mark_speed or
or
are thereby taken into
Sky Writing mode.
149.
328