Eth_Set_Search_Cards_Timeout - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command eth_set_search_cards_timeout
Function Sets a timeout value.
eth_set_search_cards_timeout( TimeOut )
Call
TimeOut
Parameters
Result None.
Comments • eth_set_search_cards_timeout is not available as a multi-board command (n_).
• The default timeout value is 5 ms.
• The timeout value is relevant for
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 606, OUT 606, RBF 611.
References eth_search_cards,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
The timeout value. In µs.
As an unsigned 32-bit value.
eth_search_cards
eth_search_cards_range
and eth_search_cards_range.
382