Fly_Return; Fly_Return_1_Axis - Scanlab RTC6 PCIe Board Installation And Operation Manual

Variable

fly_return_1_axis

List Command
Function "Fly Extension"
subsequently carries-out a jump to the specified new output position.
Restriction If the Option Processing-on-the-fly
the jump to the specified new output position.
Call fly_return_1_axis( Axis, RetPos1 )
Parameters Axis
RetPos1
Comments • Being an
"Classic" Processing-on-the-fly commands (see Footnote,
• See
""Fly Extension" Commands", page
• Axis needs to be a linear axis (1,
a Rotary
• fly_return_1_axis only deactivates 1
has been activated by an
• If no Processing-on-the-fly functionality is active at the specified Axis, only the jump is
carried out.
• With an unallowed parameter value, fly_return_1_axis is replaced by a
(get_last_error
• See also comments on fly_return.
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 617, OUT 617, RBF 623.
References fly_return_2_axes,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Command: Deactivates 1
Axis from Table 3, page
As an unsigned 32-bit value.
Absolute axis coordinate of the new output position. In bits.
As a signed 32-bit value.
Allowed value range: [–524,288...+524,287].
Out-of-range values are clipped to the boundary values.
"Fly Extension" Command, fly_return_1_axis must not be used mixed with
Chapter 8.6 "Processing-on-the-fly", page 242
axis.
"Fly Extension"
return code RTC6_PARAM_ERROR).
fly_return_3_axes
Axis of a Processing-on-the-fly application and
is not enabled, then fly_return_1_axis only carries-out
259.
and Section
259.
2 or 3). fly_return_2_axes
Axis of a Processing-on-the-fly application, if it
Command.
page 242).
is to be used to deactivate
list_nop
388