Scanlab RTC6 PCIe Board Installation And Operation Manual page 919

16.9.5 Disabling
Remote Interface Mode
Permanently
The RTC6 Ethernet Board is reset to
"Standalone Full State" when the
Remote Interface Mode is permanently disabled.
In this state, the RTC6 Ethernet Board can be
controlled via the conventional
connection.
(1) Disable Remote Interface Mode
described in Chapter 16.9.4 "Disabling
Remote Interface Mode Temporarily", page
(2) Do one of the following:
– Call eth_set_remote_tgm_format( 0 ) in
Boot Phase 1 (or remove
eth_set_remote_tgm_format( 1 ) from
Boot Phase 1)
– Set up "Standalone Basic
Chapter 16.7.2 "Preparing the
"Standalone Basic State"", page 909
(store_program( 0 ))
– Switch off the Standalone Operation Mode
all, see Chapter 16.7
"Standalone Functionality", page 908
(store_program( 1 ) or set_eth_boot_control( 0 )
RTC6 boards
Doc. Rev. 1.0.21 en-US
16 Appendix A: The RTC6 Ethernet Board
16.9.6 Error Codes for
Bit #31
Remote Interface Mode
The
(1)
RTC6 DLL-based
get_remote_error:
Error code Description
temporarily as
0
918.
1
2
State", see
at
3
4
5
6
7
(a) See telegrams.h.
get_error/get_last_error
Occurring in
Remote Interface Mode
(invalid Command Telegram) is set in
only.
Error code can be queried by
No error.
Invalid size of Command
Must be: > TGM_HEADER
 TGM_MAX_SIZE
(a)
version
value in
is not compatible with BIOS.
Make sure that C++ Remote Interface
Wrapper and BIOS
RTC6 Software Package.
(a)
Invalid length
value.
The received telegram size does not
match the size specified in telegram
header.
(a)
Invalid type
value.
Must be: 0 with a
(a)
Invalid format
value.
Must be: Same value as previously set
by eth_set_remote_tgm_format.
Invalid Remote Command-ID.
Must be: Valid Remote
from enum REMOTE_ID
Invalid payload.
Must be: 1 Remote Control Command
oder 1...n Remote List
Only
wrapper function
Telegram.
(a)
or
(a)
.
Command Telegram
are from the same
Command Telegram.
Command-ID
(a)
.
Command(s).
919