Scanlab RTC6 PCIe Board Installation And Operation Manual page 568

Variable park_return
List Command
Comments • If the laser focus has not been previously moved to a safe area by park_position, then
(cont'd) park_return is a short list command with no further effect.
• If no Processing-on-the-fly mode has been previously active or if any
Processing-on-the-fly mode is currently active, then park_return performs a normal
jump to the specified location.
• If a coordinate transformation in the virtual
most recent valid position is subsequently appropriately transformed (see
"Coordinate Transformations in the Virtual Image Field", page
• After park_return, a
• park_return switches off the
LaserOff
RTC4RTC6 New command.
In RTC4 Compatibility
The allowed value range decreases accordingly.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References park_position
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Jump Delay is activated.
Signals for "Laser Active" Operation
Delay.
Mode, the RTC6 multiplies the specified coordinate values by 16.
Image Field is active, then the specified or
169).
after a
Section
568