Select_Serial_Set; Select_Serial_Set_List - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command select_serial_set
Function Selects a serial-number-set for serial number control commands.
select_serial_set( No )
Call
No
Parameters
Comments • After initialization with load_program_file, serial-number-set 0 is selected.
• select_serial_set does not set the serial-number-set for serial number marking.
The list command
• For usage of select_serial_set, see
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References select_serial_set_list, set_serial_step,
Undelayed

select_serial_set_list

Short List
Command
Function Selects a serial-number-set for serial number list commands (as well as for serial number
marking).
select_serial_set_list( No )
Call
No
Parameters
Comments • After initialization with load_program_file, serial-number-set 0 is selected.
• For usage of select_serial_set_list, see
page
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References select_serial_set,set_serial_step_list, get_list_serial, mark_serial,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Number of the desired serial-number-set.
As an unsigned 32-bit value.
Allowed value range: [0...3].
Only the two least significant bits are evaluated.
select_serial_set_list
Number of the desired serial-number-set.
As an unsigned 32-bit value.
Allowed value range: [0...3].
Only the two least significant bits are evaluated.
210.
is intended for that purpose.
Chapter 7.5.2 "Marking Serial Numbers", page
get_serial
Chapter 7.5.2 "Marking Serial Numbers",
210.
mark_serial_abs
609