Scanlab RTC6 PCIe Board Installation And Operation Manual page 918

16.9.3 Enabling
Remote Interface Mode
(1) Configure the RTC6 Ethernet Board for
Standalone Operation Mode
"Standalone Full State", see
"Preparing the "Standalone Full State"",
910. Use store_program(
page
step 8.
(2) Make sure that eth_set_remote_tgm_format
called in Boot Phase 1, see step
Chapter 16.7.3 "Preparing the
"Standalone Full State"", page
(3) After each Hardware Reset, the RTC6 Ethernet
Board then boots in "Standalone Full State"
is then automatically set to
Remote Interface Mode.
RTC6 boards
Doc. Rev. 1.0.21 en-US
16 Appendix A: The RTC6 Ethernet Board
16.9.4 Disabling
in
The
Chapter 16.7.3
temporarily – until the next
In this state, the RTC6 Ethernet Board can be
Mode
= 3 ) in
controlled via the conventional
connection.
is
• Do one of the following:
3 in
910.
and
Remote Interface Mode
Temporarily
Remote Interface Mode can be disabled
Hardware
– Call wrapper function
disable_remote_interface
– Click the corresponding button in
– Interrupt booting into the
"Standalone Full State". During this time
(about 10 s with store_program(
step 8; otherwise, approx. 60 s), call
load_program_file. This aborts booting.
Afterwards, a conventional
connection to the RTC6 Ethernet Board can be
established.
Reset.
(1)
RTC6 DLL-based
RTC6conf.exe
Mode = 3 ) in
RTC6 DLL-based
918