Table of Contents
Advertisement
External Control Signals
The external control signals are /START and /STOP
(TTL active-LOW). Both input signals are connected
internally to +3.3 V by pull-up resistors (4,7 k), see
Figure
18. The signals are referenced to GND
also
Chapter 9.3.1 "Starting and Stopping Lists by
External Control Signals and Master/Slave
Synchronization", page
289.
BUSY List Execution Status
The
BUSY list execution status
BUSY OUT signal at pin (04). When the
BUSY list execution status
is HIGH. See also
Chapter 6.4.3 "List Execution
Status", page
108. The signal is referenced to GND
2-Bit Digital Input Port
The RTC6 PCIe Board provides a 2-bit digital
input port (DIGITAL IN1 and DIGITAL IN2).
For technical data see
Chapter 15 "Technical
Specifications – RTC6 PCIe
For programming the input port see
"2-Bit Digital Input Port", page
2-Bit Digital Output Port
The RTC6 PCIe Board provides a buffered 2-bit digital
output (DIGITAL OUT1 and DIGITAL OUT2).
For technical data see
Chapter 15 "Technical
Specifications – RTC6 PCIe
For programming the output port see
"2 Bit Digital Output Port", page
(1) See footnote on
page
73.
RTC6 boards
Doc. Rev. 1.0.21 en-US
4 RTC6 PCIe Board – Layout and Interfaces
(1)
. See
is available as the
is set, the BUSY OUT signal
(1)
.
Board",
page
873.
Chapter 9.2.2
288.
Board",
page
873.
Chapter 9.1.3
283.
12-Bit Analog Output Port 1 and 2
The RTC6 PCIe Board provides two 12-bit analog
output ports:
• ANALOG OUT1
(2)
• ANALOG OUT2
For technical data see
Chapter 15 "Technical
Specifications – RTC6 PCIe
For programming the output ports, see
Chapter 9.1.4 "12-Bit Analog Output Port 1 and 2",
page
283.
Input and Output Wiring
The input and output wiring of the
is shown in
Figure
18.
(2) The signal of
ANALOG OUT2
by the MARKING ON THE FLY socket connector, see
Section "Analog Output Port", page
Board",
page
873.
LASER Connector
is also available
82.
74
Advertisement
Table of Contents
Need help?
Do you have a question about the RTC6 PCIe Board and is the answer not in the manual?