Set_Sky_Writing_Para_List - Scanlab RTC6 PCIe Board Installation And Operation Manual

Normal List

set_sky_writing_para_list

Command
Function Like set_sky_writing_para, but a list command.
set_sky_writing_para_list( Timelag, LaserOnShift, Nprev, Npost )
Call
Timelag
Parameters
LaserOnShift
Nprev
Npost
Comments • set_sky_writing_para_list can be executed within a list, even if
Sky Writing Mode 3
Sky Writing Mode 1
• By set_sky_writing_para_list, you cannot switch from
Sky Writing Mode 3
set_sky_writing_mode_list.
• Deactivation of
set_sky_writing_para_list results in the addition of a
activation of
Jump
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
In RTC5 Compatibility
32. The allowed value range decreases accordingly.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_sky_writing_para
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Like set_sky_writing_para.
Like set_sky_writing_para.
Like set_sky_writing_para.
Like set_sky_writing_para.
is active. Here, an already-begun
and the next is started with it.
to Sky Writing Mode 1
Sky Writing Mode
Sky Writing – provided that no other delay is in effect (for example, a
Delay).
Mode, the RTC6 multiplies the value specified for LaserOnShift by
Mark Command
Sky Writing Mode 2
permanently. For this, use
1, Sky Writing Mode 2 or
Mark Delay
Sky Writing Mode 2 or
is finished with
or
Sky Writing Mode 3 by
defined prior to
741