Set_Eth_Boot_Control - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command set_eth_boot_control
Function Standalone
RTC6 Software Package 
Prerequisite
set_eth_boot_control( Ctrl )
Call
Ctrl
Parameters
Result None.
Comments • set_eth_boot_control is not executed
– the
– a list has been paused by
• During the execution of set_eth_boot_control the 10 µs clock cycle of the
interrupted for several ms.
• set_eth_boot_control is only allowed with RTC6 Ethernet Boards.
Otherwise, a
• See
• If set_eth_boot_control has not been successful,
and eth_get_error.
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 618, OUT 618, RBF 623.
References eth_boot_dcmd
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Functionality: Activates or deactivates automatic booting.
V1.7.0 and
= 0: Deactivates automatic booting.
> 0: Activates automatic booting.
As an unsigned 32-bit value.
BUSY list execution status
set_wait (PAUSED list execution status
get_last_error return code
Chapter 16.7 "Standalone Functionality", page
 26.
BIOS-ETH
return code RTC6_BUSY), if:
(get_last_error
is set
RTC6_TYPE_REJECTED
908.
Bit 27 is set, see
set)
DSP is
is generated.
eth_get_last_error
636