Scanlab RTC6 PCIe Board Installation And Operation Manual page 959

Code Code
HIGH LOW
(hex) (hex)
05 28
Notice! Generic information. May be incomplete or even incorrect for your scan system.
Code Code
HIGH LOW
(hex) (hex)
05 29
Notice! Generic information. May be incomplete or even incorrect for your scan system.
RTC6 boards
Doc. Rev. 1.0.21 en-US
20 Appendix E: iDRIVE Scan Systems – Control Commands and Signals Transmitted to RTC Boards
Data type transmitted by the scan system
As of scan-system firmware  2060.
Diagnostic flags, lower 16 bits
16-bit 20-bit –
protocol protocol
Bit #0 Bit #0 –
... ...
Bit #15 Bit #19
Always consult the dedicated scan system manual!
Module Rev.1.0.4 en-US
Data type transmitted by the scan system
As of scan-system firmware  2060.
Diagnostic flags, upper 16 bits
16-bit 20-bit –
protocol protocol
Bit #0 Bit #0 –
... ...
Bit #15 Bit #19
Always consult the dedicated scan system manual!
Module Rev.1.0.4 en-US
959