Scanlab RTC6 PCIe Board Installation And Operation Manual page 978

Code
HIGH
(hex)
As of scan system firmware  2066.
15
SetPosAcknowledgeLevel
SetPosAcknowledgeLevel
See also Chapter 8.1.6 "Configuring the PosAck Limit Value", page
See also "On SetPosAcknowledgeLevel", Seite
Code
LOW
(hex)
00
...
FF
Notice! Generic information. May be incomplete or even incorrect for your scan system.
Code
HIGH
(hex)
As of scan system firmware  2078.
17
Store/RestoreTransmissionMode
Store/RestoreTransmissionMode
data type currently selected for transmission. It can be reinstated at a later time then with
Code =
LOW
See also Data =
See also "On Store/RestoreTransmissionMode", Seite
Code
LOW
(hex)
FF
00
Notice! Generic information. May be incomplete or even incorrect for your scan system.
RTC6 boards
Doc. Rev. 1.0.21 en-US
20 Appendix E: iDRIVE Scan Systems – Control Commands and Signals Transmitted to RTC Boards
causes the scan system to switch to a certain
Desired PosAck limit value in LSB16, 16-bit protocol. In bits.
Always consult the dedicated scan system manual!
Module Rev.1.0.4 en-US
causes with
00 .
H
0527 .
H
Store temporarily
Reinstate
Always consult the dedicated scan system manual!
Module Rev.1.0.4 en-US
222.
983.
Code = FF the scan system to cache the
LOW H
983.
PosAck limit value.
978