Scanlab RTC6 PCIe Board Installation And Operation Manual page 506

Ctrl Command load_list
• load_list (ListNo = 3) is useful in scenarios such as alternating list changes, where you
Comments
(cont'd) want to wait specifically for a list to be processed (see
Changes", page
overwriting of not-yet-executed commands is thereby automatically avoided. To
instead perform unconditional loading, you can use commands such as
set_start_list_pos.
• After a successful check of the list number
USED list status
• If ListNo = 0...2 when using load_list, then note that the
change between opening of the list with load_list and the actual loading of
list commands, for example, if in the meantime an automatic list change has occurred
that has been previously defined by
where loading of a list might occur simultaneously with processing of the same list,
users must always ensure that the output pointer does not overtake the input pointer.
• In contrast, for ListNo = 3 load_list ensures that a list is actually opened for loading
only directly after processing (and after any successful automatic list changes).
Particularly, if for no list the
(for example, after initialization, after
opened list number is synchronized with the following automatic list change.
RTC4RTC6 New command.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_start_list_pos
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
111) without needing to separately query the list status. Unintentional
set), load_list behaves like
auto_change
BUSY list status
stop_execution
Section "Alternating List
(BUSY list status not set and, if applicable,
set_start_list_pos (see comments there).
BUSY list status
or start_loop. In cases such as this,
is set but for both the USED list status
or after an External
of a list can
Stop), the
506