Scanlab RTC6 PCIe Board Installation And Operation Manual page 778

Undelayed set_wobbel_vector
Short List
Command
• If activated by
applies:
– The RTC6 varies the current laser power P within the wobbel shape section according
to
– P100 (as with
wobbel figure. It is set by set_wobbel_control( Ctrl, Value, MinValue,
• With
• With
– Factor is an unsigned 16+bit value with scaling 16,384 = one (default value). The
initial Factor value can be set to nnnn by
set_wobbel_control
from the latest
– To change the 100% performance,
However, the initial Factor value only becomes effective when the
switched on newly. At wobbel shape runtime, Factor cannot be changed by
set_wobbel_control.
– Factor is changed per
set_wobbel_vector( dTrans, dLong, Period, dPower ) . The maximum value is
65,535 (Factor 4) and cannot be exceeded.
– Power modulation via
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
set_wobbel_control
P(i, n) = P 100 × (Factor + (
Mode
= 2) is the nominal laser power as it would be without the
Value
= 0...65,535, the specified
Value
= 0xFFFFFFFF, the value is taken over that has been last outputted to
the port Ctrl.
call. The parameters Ctrl,
set_wobbel_control
Microstep
McBSP
and set_wobbel_mode(
i−1
Σ
dPower j × Period j ) + dPower i × n)
j=1
Value
value is used
Value
= 0xFF00nnnn and another
MinValue
call.
set_wobbel_control
additively by the dPower value from
Mode
(as with = 2) is not possible.
Mode
= 3 ), the following
MaxValue ):
MaxValue
and are taken over
can be called at any time.
Wobbel Mode is
778