Set_Trigger8 - Scanlab RTC6 PCIe Board Installation And Operation Manual

Delayed Short

set_trigger8

List Command
Function Starts the measurement value recording of the specified measurement signals
(has the same effect as set_trigger, but with up to 8 simultaneous measurement signals).
set_trigger8( Period, Signal1, Signal2, Signal3, Signal4,
Call
Signal5, Signal6, Signal7, Signal8 )
Period
Parameters
Signal1
Signal2
Signal3
Signal4
Signal5
Signal6
Signal7
Signal8
Comments • See comments for set_trigger.
22
• 2
The measurement value recording ends automatically with 2
• A currently running measured value recording is terminated by
(no matter which of the 3 commands started it):
– set_trigger(Period
– set_trigger4(Period
– set_trigger8(Period = 0)
• Other than
increase the memory area for data recording by merging unused channels. A maximum
of 2
• The measurement value counter is reset when a new measurement value recording is
started again by:
– set_trigger(Period
set_trigger4(Period
–
– set_trigger8(Period > 0)
Already existing data are overwritten with new data.
See also the corresponding comments under set_trigger.
• As with set_trigger/set_trigger4,
to transfer the recorded values to the PC.
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of
References set_trigger, set_trigger4, stop_trigger, get_waveform,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Like set_trigger.
Like set_trigger.
Like set_trigger.
Like set_trigger.
Like set_trigger.
Like set_trigger.
Like set_trigger.
Like set_trigger.
Like set_trigger.
entries per measurement channel are available with set_trigger8.
= 0)
= 0)
set_trigger and set_trigger4, set_trigger8 does not automatically
22
entries per measuring channel is always recorded.
> 0)
> 0)
DLL 635, OUT 636.
get_waveform/get_waveform_offset
get_waveform_offset
22
data octuples.
can be used
761