Eth_Get_Last_Error - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command eth_get_last_error
Function Returns an error code which contains only the errors that have occurred during execution
of the most recent RTC6 Ethernet Board command.
EthLastError = eth_get_last_error()
Call
Parameters None.
Result Error code. Identical to eth_get_error.
As an unsigned 32-bit value.
If several errors occurred at the same time, several bits are set.
no_error = 0. No error.
wsasstartup_failed
wrong_winsock_version
Reserved.
udp_create_socket_error
udp_bind_socket_error
udp_connect_socket_error
udp_excl_add_use_error
udp_bc_ena_error
Reserved.
tcp_create_socket_error
tcp_excl_add_use_error
tcp_bind_socket_error
Reserved.
tcp_connect_socket_error
tcp_connect_sel_error
tcp_connect_fds_error
tcp_nodelay_error
create_thread_failed
udp_recv_error
udp_send_error
udp_recv_timeout
already_acquired
not_acquired
access_denied
send_tgm_timeout
card_not_found
core1_timeout
bootmode_set_failed
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Error Numeric value (2
Bit 0 1
Bit 1 2
Bit 2 4
Bit 3 8
Bit 4 16
Bit 5 32
Bit 6 64
Bit 7 128
Bit 8 256
Bit 9 512
Bit 10 1024
Bit 11 2048
Bit 12 4096
Bit 13 8192
Bit 14 16384
Bit 15 32768
Bit 16 65536
Bit 17 131072
Bit 18 262144
Bit 19 524288
Bit 20 1048576
Bit 21 2097152
Bit 22 4194304
Bit 23 8388608
Bit 24 16777216
Bit 25 33554432
Bit 26 67108864
Bit 27 134217728
[Bit]
)
368