Jump_Abs; Jump_Abs_3D; Jump_Abs_Drill - Scanlab RTC6 PCIe Board Installation And Operation Manual

Normal List

jump_abs

Command
Function Moves the output point (for the laser focus) along a 2D vector at jump speed from the
current position to the specified position (absolute coordinate values) within a 2D
Field.
Call jump_abs( X, Y )
Parameters X
Y
Comments • If the jump speed has not been previously explicitly set by
set_jump_speed_ctrl, then the jump is executed at a predefined jump speed of 10000
bits/ms.
• The
and remain off during the jump.
• After a
jump vector's subsequent (variable)
itself still requires a 10 µs clock cycle for execution.
• Previously accumulated coordinate transformations become effective by jump_abs,
see list item "With at_once = 2 ...",
RTC4RTC6 Unchanged functionality. In addition: increased value range.
In RTC4 Compatibility
The allowed value range decreases accordingly.
RTC5RTC6 Unchanged functionality. In addition: increased value range.
Version info Available as of DLL 600, OUT 600, RBF 600.
References set_jump_speed, set_scanner_delays, jump_rel, timed_jump_abs,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Absolute x coordinate of the jump vector end point. In bits.
As a signed 32-bit value.
Allowed value range: [–268,435,456...+268,435,455].
Out-of-range values are clipped to the boundary values.
The complete value range is only usable as a virtual
for (enabled) Processing-on-the-fly applications.
Like X (analogously).
Signals for "Laser Active" Operation
Jump Command, a (variable)
Mode, the RTC6 multiplies the values specified for X and Y by 16.
Image Field
set_jump_speed
are switched off before the jump
Jump Delay is inserted. Exception: a zero-length
Jump Delay is not executed. However, jump_abs
page 226.
Image
for example,
or
goto_xy
466