Scanlab RTC6 PCIe Board Installation And Operation Manual page 882

16.2.4 LASER Socket Connector
The LASER socket connector has 16 pins
located on the upper side of the RTC6 Ethernet
Board, see Figure 72, number 1.
The pin-out is shown in Figure
LASER1 (01)
1
LASERON (03)
/START (05)
BUSY OUT (07)
DIGITAL OUT2 (09)
DIGITAL IN2 (11)
+5 V (13)
ANALOG OUT1 (15)
Identical in construction to Würth 61201620621.
LASER socket connector: pin-out. The pitch of the pins is
2.54 mm. On RTC6 Ethernet Boards without
"DC/DC Converter", GND and GND2 are identical. On
RTC6 Ethernet Boards with Option "DC/DC
GND2 and the laser output signal are galvanically
decoupled from GND.
Notice!
• If you want to use the RTC6 Ethernet Board in
conjunction with laserDESK, observe the
following:
– laserDESK uses additional pins on the
EXTENSION 1 Socket
to control the laser.
– Refer to the extended documentation for the
LASER connector which can be found in the
laserDESK online help
(alternatively available from SCANLAB or in
laserDESK-zip, which can be downloaded
from the SCANLAB website).
(1) With RTC6 PCIe Boards: 15 pin D-SUB connector,
female.
RTC6 boards
Doc. Rev. 1.0.21 en-US
16 Appendix A: The RTC6 Ethernet Board
(1)
. It is
75.
(02) LASER2
2
(04) GND2
(06) /STOP
(08) DIGITAL OUT1
(10) DIGITAL IN1
(12) GND
(14) ANALOG OUT2
(16) NOT CONNECTED
75
Option
Converter",
Connector, for example,
Notes
• With RTC6 Ethernet Boards, GND is the ground at
the POWER connector. See
"POWER Socket Connector", page
RTC6 PCIe Board, GND is the PC ground.
• A suitable 0.2 m cable (#116048) is available
from SCANLAB, see also
Laser Control Signals
As with RTC6 PCIe Boards, see
"LASER Connector", page
pin numbers differ.
Signal RTC6 Ethernet
Board
LASERON Pin (03)
LASER1 Pin (01)
LASER2 Pin (02)
External Control Signals
As with RTC6 PCIe Boards, see
"LASER Connector", page
BUSY List Execution Status
As with RTC6 PCIe Boards, see
"LASER Connector", page
pin numbers differ.
Signal RTC6 Ethernet
Board
BUSY OUT Pin (07)
2-Bit Digital Input Port and 2-Bit Digital
Output Port
As with RTC6 PCIe Boards, see
"LASER Connector", page
pin numbers differ.
Signal RTC6 Ethernet
Board
DIGITAL IN1 Pin (10)
DIGITAL IN2 Pin (11)
DIGITAL OUT1 Pin (08)
DIGITAL OUT2 Pin (09)
Chapter 16.2.6
887. With the
Figure 76.
Chapter 4.6.1
73. However, note that the
RTC6 PCIe
Board
Pin (02)
Pin (01)
Pin (09)
Chapter 4.6.1
73.
Chapter 4.6.1
73. However, note that the
RTC6 PCIe
Board
Pin (04)
Chapter 4.6.1
73. However, note that the
RTC6 PCIe
Board
Pin (13)
Pin (06)
Pin (12)
Pin (05)
882