Eth_Set_Remote_Tgm_Format - Scanlab RTC6 PCIe Board Installation And Operation Manual

Ctrl Command eth_set_remote_tgm_format
Function Activates
Prerequisite Minimum requirement: RTC6 Software Package
eth_set_remote_tgm_format( Format )
Call
Format
Parameters
Result None.
Comments • eth_set_remote_tgm_format is only allowed with RTC6 Ethernet Boards.
Otherwise, a
• Invalid Format value: see Format= 0.
• eth_set_remote_tgm_format is not effective in normal operation.
• eth_set_remote_tgm_format is only effective in
Chapter 16.7.3 "Preparing the "Standalone Full State"", page
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of
References –
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Remote Interface Mode and sets the telegram format.
Telegram format.
As an unsigned 32-bit value.
= 0: Remote Interface Mode
= 1: Remote Interface Mode
> 1: Reserved.
get_last_error return code
DLL 640, OUT 639.
V1.16.0 and BIOS-ETH
is not enabled.
is enabled.
RTC6_TYPE_REJECTED
is generated.
Boot Phase 1, see step
910.
38.
3 in
381