Scanlab RTC6 PCIe Board Installation And Operation Manual page 621

Ctrl Command set_control_mode
Parameters Bit #10
(cont'd)
Bit #12
...
Bit #31
Comments • If execution is aborted by stop_execution, then
thus deactivating external start input ports and the counting of track delays with
respect to a the triggering event.
• If Bit #9
the start signal at /START, /START2 and the actual execution start. If
this 10 µs jitter is not present because the encoder reset then occurs synchronously
with the start signal.
• Bit #9
started within a list.
• See also
RTC4RTC6 Bit #8 cannot not be used to lock or unlock the upper 8 bits of the 16-bit digital
output port for I/O commands. The RTC6 automatically reserves these bits for
varioSCAN FLEX control by move_to. It is not possible to explicitly release these bits
(release automatically occurs by load_program_file).
Otherwise: unchanged functionality for the bits that are also used on the RTC4.
RTC5RTC6 Unchanged functionality.
Version info Available as of DLL 600, OUT 600, RBF 600.
Last change DLL 605, OUT 605:
References set_control_mode_list, set_extstartpos, get_counts, set_max_counts,
get_startstop_info,
RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
Track delay configured by simulate_ext_start,
= 1:
set_ext_start_delay
beginning with the most recent externally (but not with
execute_list_pos
The interval between subsequent
pulses) is thus constant, see also
External Starts", page
external stop signal, Bit #10 gets reset to "0".
= 0: Track delay configured by simulate_ext_start,
set_ext_start_delay
beginning with the time point an
requested (that is, with the corresponding
simulate_ext_start
or external start signal). The interval between subsequent
External
Reserved.
...
Reserved.
= 0, then there is generally a small (random) time offset (10 µs jitter) between
= 0 is useful, when several separate
Section "External Stop", page 289
Bit #4.
move_to
or set_ext_start_delay_list
etc.) triggered or simulated
External
Section "Regular (Periodic)
293. For stop_execution
or set_ext_start_delay_list
External Start
or simulate_ext_start_ctrl
Starts (in encoder pulses) can thus vary.
Bit #0 and Bit #10
Processing-on-the-fly
and Section "External Start", page
is counted
External Start.
Starts (in encoder
or an
is counted
has been
command
gets reset to zero,
Bit #9 = 1, then
Sessions are to be
290.
621