Restrictions With Rtc6 Pcie Boards; Availability Of Technical Variants; Peripheral Interfaces; Functionality - Scanlab RTC6 PCIe Board Installation And Operation Manual

2.11.3 Restrictions with
RTC6 PCIe Boards

Availability of Technical Variants

RTC6 boards are available as RTC6 PCIe Boards and
RTC6 Ethernet Boards.

Peripheral Interfaces

The ADC add-on card (#121126, optional accessory
for the RTC5 PCI board) cannot be used with the
RTC6 PCIe Board. The RTC6 PCIe Board supplies the
two 10 V analog input ports
ANALOG IN1 at the McBSP/ANALOG
socket connector directly, see
"McBSP/ANALOG Socket Connector", page

Functionality

With RTC6 PCIe Boards, the McBSP/ANALOG
socket connector cannot be used in
also Chapter 4.6.6 "McBSP/ANALOG Socket
Connector", page 84.
Known restrictions are mentioned in
RTC6_Release_Notes_Rev.n.n.n.pdf.
RTC6 boards
Doc. Rev. 1.0.21 en-US
2 Product Overview
ANALOG IN0 and
Chapter 4.6.6
84.
SPI mode, see
2.12 Source Code for RTC6 User
Programs
2.12.1 Creating New RTC6 Source
Code
To create new source code for RTC6 user programs,
proceed as described in Chapter 6.2 "Initialization
and Program Start-Up", page 95
Chapter 2.12.2 "Adapting RTC5 Source Code for the
RTC6 PCIe Board", page 60.
2.12.2 Adapting RTC5 Source Code
for the RTC6 PCIe Board
User programs written for the RTC5 only become
usable on the RTC6 PCIe Board, if you modify the
program code as described in the following.
This is true even if program flow remains unchanged.

Mandatory Steps

(1) Ensure the following prerequisites are met:
– RTC6 PCIe Board is installed
– RTC6 board driver is installed for your
operating system
– The following files are present:
RTC6DLL.dll or RTC6DLLx64.dll,
RTC6OUT.out
(with RTC6 PCIe Boards) or
RTC6ETH.out
(with RTC6 Ethernet Boards),
RTC6RBF.rbf,
RTC6DAT.dat,
*.CT5 (correction file(s))
Note, RTC6OUT.out/RTC6ETH.out, RTC6RBF.rbf,
RTC6DAT.dat
must all be in the same folder.
while observing
60