ST−8
STARTING (2UZ−FE)
4.
Using a magnetic finger, remove the steel ball from the clutch
Magnetic Finger
shaft hole.
HINT:
At the time of assembly, please refer to the following item.
Apply grease to the steel ball and insert the steel ball into the
clutch shaft hole.
ST0948
5.
(a)
(b)
HINT:
At the time of assembly, please refer to the following item.
B04654
Use a new O−ring.
(c)
NOTICE:
Check that the positive (+) lead wires are not grounded.
6.
P10568
−
STARTER
REMOVE STEEL BALL
REMOVE BRUSH HOLDER
Remove the 2 screws w/ O−ring and end cover from the
field frame.
Torque:
1.4 kW type: 1.5 N·m (15 kgf·cm, 13 in.·lbf)
2.0 kW type: 3.8 N·m (39 kgf·cm, 34 in.·lbf)
Remove the O−ring from the field frame.
Using a screwdriver, hold the spring back and disconnect
the brush from the brush holder. Disconnect the 4
brushes, and remove the brush holder.
REMOVE ARMATURE FROM FIELD FRAME