Toyota Tundra 2005 Service - Repair - Maintenance page 2155

ST−22
(4) (2)
(3)
(1)
(5)
STARTING (1GR−FE) − STARTER (2.0 kW)
REASSEMBLY
1. INSTALL STARTER BRUSH HOLDER ASSY
(a) Apply grease to the bearings, and install it to the starter
yoke.
(b) Place the brush holder on the armature.
(c) Using a screwdriver, install the 4 brushes.
(d) Install a new O−ring to the groove of the field frame.
A23174
(e) Install the end frame with the 2 screws.
Torque: 3.8 N m (39 kgf cm, 34 in. lbf)
A23173
2. INSTALL MAGNET STARTER SWITCH ASSY
(a) Apply grease to the steel ball, and install it to the clutch
shaft hole.
(b) Apply grease to the these parts (2) − (5), and install them
to the starter drive housing.
(1) Starter magnet switch return spring
(2) Starter idle gear pinion
(3) Starter idle gear clutch roller
(4) Starter idle gear retainer
A23172
(5) Starter clutch
(c) Install the magnet starter switch with the 2 screws.
Torque: 9.3 N m (95 kgf cm, 82 in. lbf)
A23171
ST0PZ−01