Toyota Tundra 2005 Service - Repair - Maintenance page 2154

Continuity
Ohmmeter
Ohmmeter
(A)
Lock
Terminal C
Continuity
Continuity
STARTING (1GR−FE)
9.
Using an ohmmeter, check that there is continuity between the
field coil end and field frame.
If there is no continuity, repair or replace the field frame.
P00299
10.
Using an ohmmeter, measure the resistance between shunt
coil terminals (A) and (B).
(B)
If the resistance is not as specified, replace the field frame.
S02267
11.
Free
Rotate the pinion gear clockwise, and check that it turns freely.
Check that it locks by rotating the pinion gear counterclockwise.
If necessary, replace the clutch assembly.
P10821
12.
(a)
Terminal 50
If there is no continuity, replace the magnet starter switch.
A23179
(b)
Terminal 50
If there is no continuity, replace the magnet starter switch.
A23180
− STARTER (2.0 kW)
INSPECT SHUNT COIL FOR OPEN CIRCUIT
INSPECT SHUNT COIL FOR OPEN CIRCUIT
Resistance: 1.5 to 1.9 Ω at 20 °C (68 °F)
INSPECT CLUTCH PINION GEAR
INSPECT MAGNET STATER SWITCH
Check the pull−in coil for open circuit.
(1) Using an ohmmeter, check that there is continuity
between terminal 50 and C.
Check whether or not the hold−in coil has an open circuit.
(1) Using an ohmmeter, check that there is continuity
between terminal 50 and the switch body.
ST−21