Toyota Celica 2005 Repair Manual page 1124

3 Check airbag sensor assembly.
Instrument Panel Wire
P Squib
Airbag
Sensor
Assembly
→ ←
P− P+
DLC3
CG
TC
H01023
H02144 AB0118
H01075
H10600
OK
2005 CELICA (RM1131U)
DIAGNOSTICS
PREPARATION:
(a)
(b)
(c)
CHECK:
(a)
ON
(b)
(c)
DTC B0107/51
(d)
(e)
OK:
HINT:
H10615
Codes other than code B0107/51 may be output at this time, but
they are not relevant to this check.
− SUPPLEMENTAL RESTRAINT SYSTEM
Connect the connector to the airbag sensor assembly.
Using a service wire, connect P+ and P− of the instrument
panel wire connector on the front passenger airbag as-
sembly (P squib) side.
Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Clear the DTC stored in memory (See page DI−884).
Turn the ignition switch to LOCK, and wait at least for 10
seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Check the DTC (See page DI−884).
DTC B0107/51 is not output.
NG Replace airbag sensor assembly.
1123
DI−923