Toyota Celica 2005 Repair Manual page 1109

DI−908
3 Check airbag sensor assembly.
Spiral
Cable
D Squib
D−
D+
DLC3
CG TC
H01002
AB0118
H02144
W02042
H10600
OK
2005 CELICA (RM1131U)
DIAGNOSTICS
PREPARATION:
(a)
(b)
Airbag
Sensor
Assembly
(c)
→ ←
CHECK:
(a)
ON
(b)
(c)
DTC B0102/11
(d)
(e)
OK:
HINT:
H10105
Codes other than code B0102/11 may be output at this time, but
they are not relevant to this check.
− SUPPLEMENTAL RESTRAINT SYSTEM
Connect the connector to the airbag sensor assembly.
Using a service wire, connect D+ and D− of the connector
on the spiral cable side between the airbag sensor as-
sembly and the steering wheel pad (D squib).
Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Clear the DTC stored in memory (See page DI−884).
Turn the ignition switch to LOCK, and wait at least for 10
seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Check the DTC (See page DI−884).
DTC B0102/11 is not output.
NG Replace airbag sensor assembly.
1108