Toyota Celica 2005 Repair Manual page 1122

4 Check P squib.
P Squib
Airbag
Sensor
Assembly
→ ←
ON
DLC3
CG
TC
H01024
AB0119
H10600 H01078
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check.
2005 CELICA (RM1131U)
DIAGNOSTICS
PREPARATION:
(a)
(b)
(c)
(d)
CHECK:
(a)
(b)
(c)
DTC B0106/54
(d)
(e)
OK:
H10614
HINT:
Codes other than code B0106/54 may be output at this time, but
they are not relevant to this check.
− SUPPLEMENTAL RESTRAINT SYSTEM
Turn the ignition switch to LOCK.
Disconnect the negative (−) terminal cable from the bat-
tery, and wait at least for 90 seconds.
Connect the front passenger airbag assembly (P squib)
connector.
Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Clear the DTC stored in memory (See page DI−884).
Turn the ignition switch to LOCK, and wait at least for 10
seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Check the DTC (See page DI−884).
DTC B0106/54 is not output.
NG Replace front passenger airbag assembly
(P squib).
1121
DI−921