Toyota Celica 2005 Repair Manual page 1102

4 Check D squib.
→ ←
Spiral
Cable
D Squib
ON
DLC3
CG
TC
H01003
AB0119
FI1390
H10600
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check.
2005 CELICA (RM1131U)
DIAGNOSTICS
PREPARATION:
(a)
(b)
Airbag
Sensor
(c)
Assembly
(d)
CHECK:
(a)
(b)
DTC B0100/13
(c)
(d)
(e)
OK:
H10599
HINT:
Codes other than code B0100/13 may be output at this time, but
they are not relevant to this check.
− SUPPLEMENTAL RESTRAINT SYSTEM
Turn the ignition switch to LOCK.
Disconnect the negative (−) terminal cable from the bat-
tery, and wait at least for 90 seconds.
Connect the steering wheel pad (D squib) to the spiral
cable.
Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Clear the DTC stored in memory (See page DI−884).
Turn the ignition switch to LOCK, and wait at least for 10
seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Check the DTC (See page DI−884).
DTC B0100/13 is not output.
NG Replace steering wheel pad (D squib).
1101
DI−901