Toyota Celica 2005 Repair Manual page 1119

DI−918
4 Check P squib.
P Squib
→ ←
ON
DLC3
CG
TC
H01024
AB0119
H10600 H01077
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check.
2005 CELICA (RM1131U)
DIAGNOSTICS
Airbag
Sensor
Assembly
DTC B0105/53
H10612
− SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATION:
(a) Turn the ignition switch to LOCK.
(b) Disconnect the negative (−) terminal cable from the bat-
tery, and wait at least for 90 seconds.
(c) Connect the front passenger airbag assembly (P squib)
connector.
(d) Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
CHECK:
(a) Turn the ignition switch to ON, and wait at least for 10 se-
conds.
(b) Clear the DTC stored in memory (See page DI−884).
(c) Turn the ignition switch to LOCK, and wait at least for 10
seconds.
(d) Turn the ignition switch to ON, and wait at least for 10 se-
conds.
(e) Check the DTC (See page DI−884).
OK:
DTC B0105/53 is not output.
HINT:
Codes other than code B0105/53 may be output at this time, but
they are not relevant to this check.
NG Replace front passenger airbag assembly
(P squib).
1118