Show Ip Protocol-Queue-Mapping - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

show ip protocol-queue-mapping

Display the CPU queue mapping for IPv4 protocols.

C9000 Series

show ip protocol-queue-mapping queue-id

Not configured.

Command Modes

EXEC Privilege

Usage Information The show output displays information on CPU traffic flows for IPv4 protocols, including

the ingress queue at which the traffic is queued and the CPU to which protocol traffic is

sent with the applied rate limits (configured or default) in kilobits per second (kbps). The

egress port queues on CPUs are abbreviated as: RP (Route Processor), CP (Control

Processor), and LC (line card).

Command History

This guide is platform-specific. For command information about other platforms, refer

to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Dell#show ip protocol-queue-mapping

UDP (DHCP-R)

Introduced on the C9010.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Control Plane Policing (CoPP)

Table of Contents